My build progress

[CTorp]

Thank you!

Short answer is no there are no plans. I built as I went but I talk about it a little here with some general dimensions and pics:

KOSMO Setup pics

[image] I more or less just built as I went but here are some quick notes/details. The back panel is not shown but it’s just 1/4” cheapo particle board stuff. I rabbited all the edges of the rails and the backs of the sides with a table saw so modules and back panel flush up to the case, but this isn’t necessary. Also used a “pocket jig” to hide screws/hardware. Also not necessary but it looks better: [image]

And

KOSMO Setup pics

Yes the top and bottom rails are angled to match the sides. The middle is made from two pieces glued and brad-nailed together because like you said it has two different angles: [image] [image] Hope this helps. Like i said i kinda just built as I went along (have a couple of modules with you to dry fit and back-check) and just had to figure out a solution here, especially at the mid rail. You can see my angle on the top of the mid rail is not perfect—from front you couldn’t tell, but being …