8-Step Arduino Sequencer

[fredrik]

@TayBae

Really? I thought the 5V pin was meant to act as an output.

It’s connected to the internal +5V rail. If you have a stable 5V, you can power the Nano that way:

Design glitches: Arduino Nano supply voltage

(thought I’d collect my nano supply notes in one place to make it easier to link to) A common design glitch in circuits that use an Arduino Nano is to connect regulated 5 V to the VIN pin instead of the +5V pin. This results in the Arduino running at a lower internal supply voltage, often 4 V or below, which may be a problem if the design depends on analog inputs or digital output levels. Voltages below 4.5 V are also out of spec for the 16 MHz clock used by the Nano. Details below, but TL;DR …