Non 3340 oscillators

[analogoutput]

@eric

(All these were shared by @analogoutput somewhere on this forum…)

In the FAQ category, funnily enough

PCB fabrication

An introduction to getting printed circuit boards (or PCB-type front panels) fabricated. First someone needs to design the PCB. Let’s assume that’s done already. Then they have to produce the files known as Gerbers that describe the PCB for the fabricator (and the drill files, usually included with the Gerbers though technically they’re not Gerbers). Let’s assume that’s done already too. You’ve found a repository that has Gerbers for a PCB you want; what do you do? Submitting Gerbers In short,…