# APC sequencer (was Isn't this wrong a bit) **URL:** \ **Category:** DIY STUFF\ **Created:** [October 28, 2022, 7:01pm UTC](https://lookmumnocomputer.discourse.group/t/apc-sequencer-was-isnt-this-wrong-a-bit/5588 "2022-10-28T19:01:44Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![analogoutput](https://yyz2.discourse-cdn.com/free1/user_avatar/lookmumnocomputer.discourse.group/analogoutput/32/29663_2.png) [@analogoutput](https://lookmumnocomputer.discourse.group/u/analogoutput)\ **Post date:** [October 28, 2022, 8:45pm UTC](https://lookmumnocomputer.discourse.group/t/apc-sequencer-was-isnt-this-wrong-a-bit/5588/2 "2022-10-28T20:45:45Z")
Yeah, the connections to the 4066 should have diodes and a pulldown resistor. And I’m not sure what’s supposed to be going on with the +V connected to the output. If you don’t need s-trigger the 4066 could be replaced with a smaller LM358. Or just go directly to the output jack, the buffering isn’t necessarily mandatory. See more discussion here: > [@Baby 8 step sequencer schematic](https://lookmumnocomputer.discourse.group/t/baby-8-step-sequencer-schematic/2441): > > I try to make schem for an old school Baby 8 seq with a CD4017, with some mix of several schem, and i’m not sure that my mix holds the road . with some on/off/on switch you can on each step select, on/off cv & gate out or choose this step as reset step. i use this part of schem for the external clock in, but only the up part (not the gate to trigger one) and i don’t really know what doing with the pin 2 of opamp, in my schem i only connect it to 100k then +12V here’s my test on… --- _[View the full topic](https://lookmumnocomputer.discourse.group/t/apc-sequencer-was-isnt-this-wrong-a-bit/5588)._