# \#1007 midimuso midi-cv

**URL:** <https://lookmumnocomputer.discourse.group/t/1007-midimuso-midi-cv/1446>\
**Category:** FAQ\
**Created:** [July 15, 2020, 1:06pm UTC](https://lookmumnocomputer.discourse.group/t/1007-midimuso-midi-cv/1446 "2020-07-15T13:06:09Z")\
**Posts on this page:** 1\
**Showing post:** 49

<div class="post-metadata">

**Author:** ![fredrik](https://yyz2.discourse-cdn.com/free1/user_avatar/lookmumnocomputer.discourse.group/fredrik/32/682_2.png) [@fredrik](https://lookmumnocomputer.discourse.group/u/fredrik)\
**Post date:** [August 3, 2020, 8:05pm UTC](https://lookmumnocomputer.discourse.group/t/1007-midimuso-midi-cv/1446/49 "2020-08-03T20:05:37Z")

</div>

It depends on your supply voltage – if it’s good enough to give you ~11.5 V or above, you can use 270 ohm and save a tiny bit of power. If it may drop below that, you may have to use a lower value to make sure the TL431 gets the 1 mA it needs to regulate. See discussion in this thread:

> [@Module requests](https://lookmumnocomputer.discourse.group/t/module-requests/39/228):
>
> Ok, I’d try 680 ohm 270 ohm in series to get a small margin, and a 5k1 resistor + 5k trimmer in the divider, to put the right position near the center of the trimmer. (270 ohm gives you at least (11.5−10.6)/270 = 3.3 mA which is 1 mA for the TL431, 1.3 mA for the circuit, and 1 mA to spare. 330 ohm could work but then it’s getting a bit tight at 11.5 V) EDIT: 220 ohm is probably better, since current is flowing through 5k+5.1k as well, see [here](https://lookmumnocomputer.discourse.group/t/1007-midimuso-midi-cv/1446/51).

EDIT: 220 ohm is probably better, see [here](https://lookmumnocomputer.discourse.group/t/1007-midimuso-midi-cv/1446/51).

---

_[View the full topic](https://lookmumnocomputer.discourse.group/t/1007-midimuso-midi-cv/1446)._
